|
 Phidgets Encoder High Speed 4-Input (1047)
The PhidgetEncoder Highspeed 4-Input can be used with a wide assortment of mechanical and optical encoders. The encoder should be of quadrature output type, indicating that there will be two quadrature output channels (usually labeled A and B) and a third output channel (only on some encoders) to signal when the index pin (a reference point for zero position or a complete revolution) has been reached.
Part Number: 1047
|
 Phidget Encoder #1052
The PhidgetEncoder is intended to be used as a human interface, not as a device to measure shaft speed of motors or pulleys. If you are looking for an encoder to measure shaft speed, have a look at the 1057 PhidgetEncoder HighSpeed.
|
 Phidget Encoder High Speed #1057
The PhidgetEncoder HighSpeed connects to any typical two-bit optical encoder and can return up to 500,000 counts per second. Specifically it reads a standard incremental non-differential TTL encoder.
|
 Phidgets Rotation Sensor #1109
The 1109 can be rotated 300 degrees and outputs a number between 0 and 1000 based on the shaft position. The maximum resistance of the potentiometer is 10K ohm.
|
 Phidgets 60mm Slider #1112
The Slider 60 is a linear potentiometer - the resistance varies linearly with the position of the slider. SensorValue varies from 0 to1000 over the 60mm travel of the slider. The maximum resistance is 10K ohms.
|
 Phidgets Mini Joy Stick Sensor #1113
This miniature joystick has two axes and a pushbutton. Each axis, up/down and left/right, has a potentiometer with a center value of approximately 500. When you move the Joystick from its center position the value will increase or decrease depending on the direction.
|
|
Phidget Multi-turn Rotation Sensor #1116